Support for 12W Solar Fountain Pump with Battery

This page covers the 12W Solar Fountain Pump with Battery, model P112D, with manual P023. Match the model and supplied parts before following a shared tutorial.

P023 is the manual reference for this kit. Shared manuals can illustrate another wattage or pump finish. Use this page’s model-specific specifications and match your supplied fittings; do not use another model’s performance ratings.

Yes, this model can use stored battery energy after sunset. Runtime depends on the charge, sunlight and operating conditions; continuous overnight operation is not guaranteed.

Put the panel outdoors in direct sunlight without shade from trees, walls or railings. Secure its supplied mounting hardware and leave slack in the cable.

Check water level and connectors first. If the battery is low, disconnect the pump and charge the panel in full sunlight before testing again. The manual recommends at least 6 hours for this troubleshooting check; weather affects the result.

Solar intensity, lift, tubing length, nozzle restrictions and split flow affect output. Test in strong sun with the filter clean and remove the spray head briefly to check whether it is restricted.

Use the nozzle or the tubing arrangement shown in the manual. Do not assume that a small-pump kit includes a dual-outlet diverter.

Fully submerge the pump and keep it away from sediment. Keep the nozzle outlet above the surface. Secure the pump on a suitable surface and check the water level regularly.

Choose a lower spray pattern, center the pump and allow for wind. Check the basin often and stop the pump if water is being lost.

Follow the illustrated P023 assembly sequence. Fit the correct outlet adapter, floating board and nozzle components without forcing them. The floating board is separate from the filter sponge.

Connect compatible tubing to the pump outlet shown in the manual. Keep tubing short and free of kinks; increasing height and length reduces flow.

Use the supplied panel and compatible original parts. Ask support to verify the connector and electrical compatibility before substituting a power source.

Disconnect the panel before maintenance. Remove the intake cover and sponge, rinse away debris, and reassemble carefully. Clean the nozzle separately and follow the manual before removing the rotor.

No. Keep the pump submerged and refill as needed. Protection features do not replace monitoring, especially in hot or windy weather. Stop and inspect the setup if the pump makes unusual noise.

This kit provides a fountain and water movement. Do not rely on intermittent solar flow as the only filtration or continuous oxygen source for a stocked pond.

Send your order number, model label, photos of the parts and a short video of the issue to support@poposoapsolar.com. Check the current warranty and refund policies for eligibility and claim steps. Warranty policy · Refund policy.